The WRAP-IT-HEAT® Model SRX-55 120v Drum Heater and warmer is a drum warmer and heater that uses a specially designed method for supplying an On/ Off heat with pulsing control to control the heat transmitted to what you are warming or heating in your metal drum. The controller varies the length of the "on" segment of this cycle at the wattage determined by the user setting of the 3 HEAT Switch and then the "Off" segments of the cycle, at zero wattage output. This is particularly helpful for, and suited for heating materials that might burn or separate or "coke" like honey, chocolates, or light oils or specialty chemicals.
Model SRX-55 120V does NOT have a thermostat and will therefore not AUTOMATICALLY reach or maintain a given temperature. However, the special INFINITE control mechanism allows the user to CLOSELY control the output of the heater within a close given range of HIGH, MEDIUM or LOW. The three heat switch
allows three wattage ratings per control setting and voltage rating: HIGH = Maximum Watts; MEDIUM = 1/2 Maximum Watts and LOW = 1/4 Maximum Watts. Equipped with spring loaded toggle clamp for snug fit, 6 foot
power cord and high ampere three pin plug. For 120V operation, use NEMA 5-20 Outlet.
Model SRX-55 120V is for standard 55 gallon all METAL drums. SRX-55 cannot be used on drums made of Plastic, or have a plastic liner, or any fiber Drums.
SRX-55 120V is to be used to heat NON-FLAMMABLE, NON-COMBUSTIBLE materials only in a
The WRAP-IT-HEAT Model SRX-55 120 V Drum Heater is U.L. Listed and C.S.A. Certified.
6 ' Cord
Cord with NEMA 5-20 plug
ALWAYS READ INCLUDED INSTRUCTIONS INCLUDING ALL WARNINGS.
THESE HEATERS ARE NOT WATERPROOF. DO NOT LET THE DRUM HEATERS GET WET
DO NOT LEAVE DRUMS WITH HEATERS ON UNATTENDED